pdf Printer Friendly Version (510 KB)
When cleaning Stonewood Architectural Panels, use a progressive approach starting with the gentlest cleaning method. It is best to use the least amount of cleaning agents and no scrubbing to remove the debris in order to keep the panel looking beautiful.
Benchmark Recommendation: It is highly recommended to always test clean a small part of the affected area, and once the effectiveness of the procedure has been verified, proceed with the rest of the surface.
Cleaning Progression:
- Step 1: Clean the surface just with pure hot water and use a clean soft cloth (not dyed). Always use a wet or damp cloth, do not rub the panels when dry.
- Step 2: Washing the surface with dishwashing detergent and plenty of lukewarm water. Use a clean, soft cloth, applying light pressure. Rinse with clean water. Never use cloths or sponges with abrasive cleaning surfaces or additives as they will damage the surface of the panels.
- Step 3: Grease, oil or tar may be removed with a good grade of hexane, aliphatic naphtha or kerosene. These solvents may be obtained at a paint or hardware store and should be used in accordance with manufacturer’s recommendations. Any oily film left behind by solvents should be removed immediately by washing.
DO NOT USE: Window cleaning sprays, kitchen scouring compounds, or solvents such as acetone, Ethyl Acetate, MEK, nail polish remover, gasoline, benzene, carbon tetrachloride or lacquer thinner. They cleaning agents will cause permanent damage to the surface of the panel.
Repair: There is no approved method to repair the panels. If damaged, they must be replaced.